Cimserver Loglevel - Cisco MDS 9124 - Fabric Switch Reference

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

cimserver loglevel

To configure the cimserver loglevel filter, use the cimsever loglevel command in configuration mode.
Syntax Description
filter value
1
2
3
4
5
Defaults
None.
Command Modes Configuration mode
Command History Release
3.3(1a)
Usage Guidelines
None.
Examples The following example displays the cimserver loglevel.
switch# config
Enter configuration commands, one per line.
switch(config)# cimserver loglevel 2
Current value for the property logLevel is set to "INFORMATION" in CIMServer.
Related Commands Command
show cimserver logs
OL-16217-01, Cisco MDS SAN-OS Release 3.x
cimserver loglevel filter value
Specifies the cimserver log filter levels. The range is 1 to 5.
Sets the current value for the loglevel property to trace.
Sets the current value for the loglevel property to information.
Sets the current value for the loglevel property to warning.
Sets the current value for the loglevel property to severe.
Sets the current value for the loglevel property to fatal.
Modification
This command was introduced.
Description
Displays the cimserver logs.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
cimserver loglevel
4-25