Catalyst 6503-E - Cisco WS-C6503 Manual

Catalyst 6503-E

•
•
Note
Additional information on the Catalyst 6503 switch chassis including data sheets and chassis installation
is located at:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.html
Catalyst 6503-E
The Catalyst 6503-E switch is an enhanced version of the Catalyst 6503 switch. The 3-slot (numbered
from (1) top to (3) bottom), 4 RU, horizontal chassis supports redundant power supplies and redundant
supervisor engines. It also supports a greater power capacity per slot than the Catalyst 6503 switch
chassis and supports the WS-X67xx and WS-X68xx switching modules. The Catalyst 6503-E switch
chassis is NEBS L3 compliant. Supervisor engine support and restrictions for the Catalyst 6503-E
includes:
•
Note
•
Note
•
Catalyst 6500 Series Supervisor Engine Guide
1-2
Supervisor Engine 32, Supervisor Engine 32 PISA, and the Supervisor Engine 720 require
additional cooling. You must install the optional high-speed fan tray (FAN-MOD-3HS) in the
chassis when any of these three supervisor engines are installed.
The uplink ports are fully functional on the redundant supervisor engine when it is in standby mode.
In systems with redundant supervisor engines, both supervisor engines must be the same model
and have the same daughter card configurations. Each supervisor engine must have the resources
to run the switch on its own, which means that all supervisor engine resources are duplicated.
Identical supervisor engine memory configurations are recommended but are not required as
long as the supervisor engine with the smaller memory configuration is sufficient to run the
configured features of the switch. Additionally, each supervisor engine must have its own flash
device and console port connections.
Supervisor Engine 2, Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor Engine 720,
Supervisor Engine 720-10GE, and Supervisor Engine 2T are supported.
Refer to your software release notes for specific information on the minimum software release
versions required to support the supervisor engines in the Catalyst 6503-E chassis.
Supervisor engines must be installed in slot 1 or slot 2.
Slots not occupied by supervisor engines can be used for modules. Check your software release
notes for any restrictions on the type of module that can be installed.
Supervisor Engine 720, Supervisor Engine 720-10GE, and Supervisor Engine 2T have a built-in
switching fabric. The Switch Fabric Modules (WS-C6500-SFM and WS-X6500-SFM2) are not
supported by Supervisor Engine 720 and Supervisor Engine 720-10GE and cannot be installed in
the same chassis.
Chapter 1 Catalyst 6500 Series Switch Chassis Overview
OL-7397-03