Cisco WS-C6503 Manual page 80

Removing a Supervisor Engine
Figure 3-6
Place the removed module on an antistatic mat or in an antistatic bag, or immediately reinstall it in
Step 6
another slot.
If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain
Step 7
proper airflow through the chassis. If a Supervisor Engine 2T or a WS-X6908-10G module is installed,
the slots adjacent to either the supervisor engine or the module must have switching-module filler plates
installed (Cisco part numbers WS-X6K-SLOT-CVR-E or SLOTBLANK-09). Do not install blank slot
covers (WS-X6K-SLOT-CVR).
Blank faceplates and cover panels serve three important functions: they prevent exposure to
Warning
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Catalyst 6500 Series Supervisor Engine Guide
3-12
Removing the Supervisor Engine (Horizontal Slot Chassis Shown)
1
2
WS-X6624-FXS
3
24 PORT FXS ANALOG
STATION
WS-X6624-FXS
4
24 PORT FXS ANALOG
STATION
5
WS-X6348-RJ-45 V
6
48 PORT
10/100 BASE-T
o
INPUT FAN
OUTPU T
OK
OK FAIL
Chapter 3
ETHERNET SWITCHING
MODULE
o
INPUT FAN
OUTPU T
OK
OK FAIL
Installing Supervisor Engines
OL-7397-03