Cisco WS-C6503 Manual page 38

Supervisor Engine 32
Table 2-6 Supervisor Engine 32 Features (continued)
Feature
Memory
Switch Processor DRAM
Route Processor DRAM
Switch Processor
Bootflash/Bootdisk
Route Processor Bootflash
CompactFlash (disk0)
Front panel features
Status LEDs
RESET switch
CONSOLE port
DISK 0 (PCMCIA) slot and
LED
Catalyst 6500 Series Supervisor Engine Guide
2-10
Description
256 MB (supervisor engines shipped before May, 2005)
•
512 MB (supervisor engines shipped after May, 2005)
•
Upgradeable to 1 GB using MEM-xCEF720-1GB memory kit
•
• 256 MB (supervisor engines shipped before May, 2005)
512 MB (supervisor engines shipped after May, 2005)
•
• Upgradeable to 1 GB using MEM-xCEF720-1GB memory kit
256 MB
64 MB
Compact flash Type 2 (supports 64, 128, 256, 512 MB, and 1 GB
See Table 2-8 for a list of the status LEDs and their descriptions.
The RESET switch allows you to reset and restart the switch.
Because the reset switch is recessed in the faceplate, you must use a
Note
ballpoint pen tip or other small, pointed object to access the switch.
This is a 10/100/1000 port that uses an RJ-45 connector. The CONSOLE port
allows you to access the switch either locally (with a console terminal) or
remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control.
One PCMCIA slot is available. The PCMCIA slot allows a Flash PC card to
be installed providing additional flash memory. You can use this flash
memory to store and run software images or to serve as an I/O device. An
eject button is located on the left side, next to the slot. Pushing in on the
button ejects the PCMCIA card from the slot.
The PCMCIA slot has an LED associated with it.
Chapter 2 Supervisor Engines
OL-7397-03