Cisco WS-C6503 Manual page 76

Installing a Supervisor Engine
Figure 3-4
Press left
Press left
c. Using the thumb and forefinger of each hand, grasp the two ejector levers and exert a slight pressure
to the left, deflecting the supervisor engine approximately 0.040 inches (1 mm) creating a small gap
between the supervisor engine's EMI gasket and the module or cover plate adjacent to it. (See
Figure
Note
While gently pressing to the left on the ejector levers, simultaneously close both levers to fully seat
d.
the supervisor engine in the backplane connector. The ejector levers are fully closed when they are
flush with the supervisor engine faceplate.
e. Tighten the two captive installation screws on the supervisor engine.
Note
f. Verify that the supervisor engine STATUS LED is lit.
Periodically check the STATUS LED:
g.
Catalyst 6500 Series Supervisor Engine Guide
3-8
Clearing the EMI Gasket in a Vertical Slot Chassis
FAN
STATUS
o
o
INPUT
FAN OUTPUT
OK
OK FAIL
INPUT FAN
OUTPUT
OK OK
FAIL
3-4.)
Do not exert too much pressure on the ejector levers because they will bend and get
damaged.
Make sure that the ejector levers are fully closed before tightening the captive installation
screws.
Chapter 3 Installing Supervisor Engines
Gap between the module
EMI gasket and the
module above it
1mm
OL-7397-03