Cisco WS-C6503 Manual page 45

Chapter 2 Supervisor Engines
Table 2-10 Supervisor Engine 32 PISA Features (continued)
Feature
Memory
Switch Processor DRAM
Route Processor DRAM
Switch Processor
Bootflash/Bootdisk
Route Processor Bootflash
CompactFlash (disk0)
Front panel features
Status LEDs
RESET switch
CONSOLE port
DISK 0 (PCMCIA) slot and
LED
OL-7397-03
Description
512 MB (WS-S32-GE-PISA)
•
1 GB (WS-S32-10GE-PISA)
•
1 GB
512 MB through internal compact flash (bootdisk in CLI); upgradeable to 1 GB
256 MB
Compact flash Type 2 (supports 64, 128, 256, 512 MB, and 1 GB
See Table 2-12 for a list of the status LEDs and their descriptions.
The RESET switch allows you to reset and restart the switch.
Because the reset switch is recessed in the faceplate, you must use a
Note
ballpoint pen tip or other small, pointed object to access the switch.
This is a 10/100/1000 port that uses an RJ-45 connector. The CONSOLE port
allows you to access the switch either locally (with a console terminal) or
remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control.
One PCMCIA slot is available. The PCMCIA slot allows a Flash PC card to be
installed providing additional flash memory. You can use this flash memory to
store and run software images or to serve as an I/O device. An eject button is
located on the left side, next to the slot. Pushing in on the button ejects the
PCMCIA card from the slot.
The PCMCIA slot has an LED associated with it.
Supervisor Engine 32 PISA
Catalyst 6500 Series Supervisor Engine Guide
2-17