Http; Discovery Settings; Qos - Cisco WVC200 - Wireless-G PTZ Internet Camera Administration Manual

Configuring the Cisco WVC210 Internet Camera Software
Setup > Advance Settings
WVC210 Wireless-G PTZ Internet Video Camera With 2-Way Audio Administration Guide
• Enable Multicast—The camera's video and audio IP addresses have been
pre-configured and can be used for multicasting. Normally these settings
do not need to be reconfigured. If an address does need to be changed,
please contact your network administrator and refer to the camera's online
Help.

HTTP

• HTTP Port—The default port of 80 is the port your web browser uses to
access your camera. If a different port is entered, HTTP connections (from
your web browser, viewer and recorder utility) can use that port instead of
the standard HTTP port 80 to access the camera. The supported port
numbers are in the range of 1024 to 65534. If you change the port number,
when you open the URL to the camera, you now must specify the port
number, for example: http://192. 1 68. 1 28.23:8002. You must specify the port
for either LAN or WAN connections.

Discovery Settings

• Enable UPnP (Discover Only)—If enabled, the camera will broadcast its
availability through Universal Plug and Play protocol. UPnP compatible
systems such as Windows XP will then be able to detect the presence of
the camera. For instructions on setting UPnP on your system, see
"Questions and Answers," on page
• Enable Bonjour—Enabled by default. If enabled, the Cisco WVC210 IP
Camera is accessible through a Bonjour-enabled browser, such as
Microsoft Internet Explorer with a Bonjour plug-in, or the Apple Mac Safari
browser. By using Bonjour, you can easily find and click on Bonjour-enabled
items on your network.

QoS

• Enable QoS Mode—Check to enable Quality of Service (QoS) for media
streams.
• DSCP—If QoS is enabled, please enter the Differentiated Services Code
Point (DSCP) to be used on processing QoS packets. The default value is
12.
89.
8
55