Configure - Cisco AS5350 - Universal Access Server Configuration Manual

Configuring the Universal Port Card and Lines
Table 3-4
Feature
In-band signaling/tone generation and
detection
Other

Configure

Configure the lines and ports to allow users to dial in to your network.
Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# spe country country name
Step 4
AS5400(config)# line slot/port slot/port
AS5400(config-line)#
Step 5
AS5400(config-line)# transport input all
Step 6
AS5400(config-line)# autoselect ppp
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
3-28
Modem Standards and Supported Features (continued)
Chapter 3 Basic Configuration Using the Command-Line Interface
Description
DTMF generation
DTMF detection
MF generation
MF detection
Out-of-band access for management
PPP and SLIP framing
Purpose
Enters the enable command. Enters your
password. You are in privileged EXEC mode when
the prompt changes to
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
AS5400(config)#.
Specifies the country to set the universal-port-card
parameters (including country code and
encoding). This setting is applied at the system
level. All universal port cards use the same
country code. The default is usa if the gateway is
configured with T1 interfaces and e1-default if
the gateway is configured with E1 interfaces. Use
the no form of this command to set the country
code to the default of domestic.
Note All sessions on all universal port cards in
all slots must be IDLE for this command to
execute.
Enters the numbers of the ports to configure. If
you wish to configure 108 ports on slot 3, enter
line 3/00 3/107. If you wish to configure 324 ports
on slots 3-5, enter line 3/00 5/107.
Allows all protocols to be used when connecting
to the line.
Enables remote IP users running a PPP application
to dial in, bypass the EXEC facility, and connect
directly to the network.
or .
AS5350# AS5400#
or
OL-3418-02 B0