Cisco AS5350 - Universal Access Server Configuration Manual page 155

Appendix
There are 10 controllers on this access server. If you want to use
the full capacity of the access server configure all controllers.
Controller CT3 0,1...etc
on the back of the access server.
PRI configuration can be configured to controllers all at once
based on your PRI controllers selection. Whereas CAS configuration
will be configured individually for each controller.
Enter the number of controllers you will be using for the PRI configuration or press Enter to configure
Step 13
all controllers.
Enter # of controllers, you will be using for PRI configuration [28]:
Configuring controller parameters:
Press Enter for every slot, port, and channel.
Step 14
Configuring controller t1 3/0:1
Configuring PRI on this controller.
.
.
.
.
Configuring controller t1 3/0:28
Enter yes to use robbed bit signaling on the controller.
Step 15
Will you be using CT1 (robbed-bit signaling) on this controller? [yes]: yes
Enter your telco framing type.
Step 16
The following framing types are available: esf | sf
Enter the framing type [esf]:
Step 17 Enter your telco line code type.
The following linecode types are available: ami | b8zs
Enter the line code type [b8zs]:
Enter the letter corresponding to the signaling type to support modem pooling over the T1 lines or press
Step 18
Enter to accept the default.
The following line signaling types are available
[a] e&m-fgb
[b] e&m-fgd
[c] e&m-immediate-start
[d] fgd-eana
[e] fgd-os
[f] fxs-ground-start
[g] fxs-loop-start
[h] none
[i] r1-itu
[j] r1-modified
[k] r1-turkey
[l] sas-ground-start
[m] sas-loop-start
OL-3418-02 B0
in software corresponds to Port 0,1...etc
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Getting Started
-5