Save The Configuration File - Cisco AS5350 - Universal Access Server Configuration Manual

Appendix
Enter yes to configure the FastEthernet0/0 interface to connect the gateway to a LAN, then respond to
Step 14
the remaining questions to configure the FastEthernet port (you can also press Enter to accept the
default):
Do you want to configure FastEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Repeat
Step 15
Configure your serial interfaces by responding to the following prompts:
Step 16
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Repeat
Step 17
After you complete the configuration script, the setup script displays the configuration command script.
Go to the next section
Step 18

Save the Configuration File

Step 1 Enter 0, 1, or 2 when the following prompt is displayed:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
%LINK-3-UPDOWN: Interface Serial0, changed state to down
%LINK-3-UPDOWN: Interface Serial1, changed state to down
<Additional messages omitted.>
OL-3418-02 B0
Full duplex mode enables simultaneous data transfer between a sending and a receiving station.
Step 14 to configure any other FastEthernet ports, if necessary.
Assign to which interface [FastEthernet0/0]:
Step 16 to configure any other serial interfaces, if necessary.
"Save the Configuration
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
interface? [yes]: yes
interface? [no]: yes
File."
Save the Configuration File
-15