Important Upgrade Commands; Displaying Spe Firmware Versions - Cisco AS5350 - Universal Access Server Configuration Manual

Chapter 5 Managing and Troubleshooting the Universal Port Card

Important Upgrade Commands

There are several commands you use to upgrade SPE firmware. For examples on using the commands,
see the
SPE Firmware Bundled with Cisco IOS Software" section on page
•
•
•
The copy ios-bundled command is not necessary with the universal port card. By default, the version of
Note
SPE firmware bundled with the Cisco IOS software release transfers to all SPEs not specifically
configured for a different SPE firmware file.

Displaying SPE Firmware Versions

Use the show spe version command to list the versions of SPE firmware running on the SPEs, residing
in system Flash memory, and bundled with Cisco IOS software. This helps you decide if you need to
change the version running on the modems.
Note The version number (version column) may not match the filename (UPG firmware-filename column) for
a short period of time while a range of SPEs is in the process of downloading new firmware. The version
number updates at the beginning of the upgrade process, whereas the filename updates upon completion
of the process. This is done intentionally to enable you to recognize the upgrade process from the show
spe version output.
AS5400# show spe version
IOS-Bundled Default Firmware-Filename
=====================================
system:/ucode/np_spe_firmware1
On-Flash Firmware-Filename
==========================
flash:np.spe
flash:np_6_77.spe
flash:np_6_79.spe
OL-3418-02 B0
"Upgrading SPE Firmware from the Cisco.com FTP Server" section on page 5-14
Use the copy tftp flash filename command to copy any version of SPE firmware (no matter how it
is obtained) into system Flash memory. You can store several versions of the SPE firmware in system
Flash memory under different filenames.
Use the firmware location SPE configuration command to transfer a specified version of SPE
firmware from system Flash memory to the SPEs named on entering SPE configuration mode.
Use the firmware upgrade busyout | download-maintenance | reboot SPE configuration command
to configure when the file named in the firmware location command will be loaded to the SPEs.
Three methods of upgrade are available:
Busyout (the default) upgrades when all calls are terminated on an SPE.
–
Download-maintenance waits upgrades at the next download maintenance (see the
–
Download Maintenance" section on page
03:00.
Reboot upgrades at the next reboot. Note that, for the firmware upgrade reboot command to
–
take effect after a reload, you must have saved the running configuration with the copy
running-config startup-config command.
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
5-20.
5-11). The default download-maintenance time is
Version Firmware-Type
======= =============
0.0.6.75 SPE firmware
Version Firmware-Type
======= =============
0.6.4.5 SPE firmware
0.0.6.77 SPE firmware
0.0.6.79 SPE firmware
Upgrading SPE Firmware
and the "Using
"SPE
5-13