Cisco AS5350 - Universal Access Server Configuration Manual page 156

Getting Started
Step 19 Enter the tone signaling type.
The following tone signaling types are available:
Enter the tone signal type [dtmf]:
Enter yes to configure digital number identification service (DNIS).
Step 20
Do you want to provision DNIS address information? [yes]: yes
Repeat
Step 21
Step 22 Enter yes to configure the FastEthernet0/0 interface to connect the gateway to a LAN, then respond to
the remaining questions to configure the FastEthernet port.
Do you want to configure FastEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Note
Operate in full-duplex mode? [no]:
Operate at 100 Mbps speed? [yes]:
Configure IP on this interface? [yes]:
IP address for this interface [X.X.X.X]: 172.22.50.10
Subnet mask for this interface [255.255.0.0] :
Class B network is 172.22.0.0, 16 subnet bits; mask is /16
Step 23 Repeat
Configure your serial interfaces by responding to the following prompts:
Step 24
Do you want to configure Serial0/0
Configure IP on this interface? [no]: yes
Configure IP unnumbered on this interface? [no]:
Assign to which interface [FastEthernet0/0]:
Step 25 Repeat
After you complete the configuration script, the setup script displays the configuration command script.
Go to the
Step 26
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
-6
dtmf | mf
Step 15 to Step 20 to configure the remaining controllers.
Full duplex mode enables simultaneous data transfer between a sending and a receiving station.
Step 22 to configure any other FastEthernet ports, if necessary.
Step 24 to configure any other serial interfaces, if necessary.
"Save the Configuration File" section on page
interface? [yes]: yes
interface? [no]: yes
A-15.
Appendix
OL-3418-02 B0