Spe Configuration Mode - Cisco AS5350 - Universal Access Server Configuration Manual

Managing SPEs

SPE Configuration Mode

SPE configuration mode allows you to enter SPE configuration mode, which is similar to line
configuration mode. You can configure an SPE by specifying a slot and an SPE associated with the slot
or, you can choose to configure a range of SPEs by specifying the first and last SPE in the range.
The following example demonstrates how to enter SPE configuration mode.
AS5400# config t
Enter configuration commands, one per line.
AS5400(config)# spe 1/1 1/17
AS5400(config-SPE)#
SPE Configuration Mode Commands
The following commands are available in SPE configuration mode:
•
•
•
•
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
5-8
4/11 0066-0071 ACTIVE
4/12 0072-0077 ACTIVE
4/13 0078-0083 ACTIVE
4/14 0084-0089 ACTIVE
4/15 0090-0095 ACTIVE
4/16 0096-0101 ACTIVE
4/17 0102-0107 ACTIVE
firmware location—Allows you to transfer a specified version of SPE firmware from system Flash
memory to the SPEs named upon entering SPE configuration mode. For further information on
firmware upgrades, see the
firmware upgrade busyout | download-maintenance | reboot—Allows you to specify the upgrade
method. Three methods of upgrade are available.
Busyout (the default) upgrades when all calls are terminated on an SPE.
–
Download-maintenance waits upgrades at the next download maintenance. For further
–
information on firmware upgrades, see the
The default download-maintenance time is 03:00.
Reboot upgrades at the next reboot. Note that, for the firmware upgrade reboot command to
–
take effect after a reload, you must have saved the running configuration with the copy
running-config startup-config command.
busyout—Gracefully disables an SPE by waiting for all the active services on the specified SPE to
terminate. If there are active ports on the specified SPE, the state of the SPE is changed to Busiedout.
The SPE is temporarily disabled. Use the no form of this command to re-enable the SPEs.
shutdown—Clears active calls on all ports on the SPE. Calls can no longer be placed on the SPE
because the SPE state is changed to Out-of-Service. The state of the SPEs is reflected in the show
spe command display. Use the no form of this command to re-enable the ports on the SPE.
Chapter 5
0 0
0 0
0 0
0 0
0 0
0 0
0 0
End with CNTL/Z.
"Upgrading SPE Firmware" section on page
"Upgrading SPE Firmware" section on page
Managing and Troubleshooting the Universal Port Card
0 ______ ______
0 ______ ______
0 ______ ______
0 ______ ______
0 ______ ______
0 ______ ______
0 ______ ______
5-12.
5-12.
OL-3418-02 B0