Cisco AS5350 - Universal Access Server Configuration Manual page 119

Chapter 5 Managing and Troubleshooting the Universal Port Card
Step 6 Type the exit command to exit SPE config mode.
AS5400(config-SPE)# exit
AS5400(config)#
Step 7 Press the Enter key to verify your command registers, then type Ctrl-Z to return to privileged EXEC
mode.
AS5400(config)# Ctrl-Z
AS5400#
Save your changes when ready.
Step 8
AS5400# copy running-config startup-config
This process does not delete any existing SPE firmware that resides in system Flash memory in case you
later want to revert to it. If you decide to delete the code from system Flash memory, remember that all
files in system Flash memory are deleted; therefore save and restore any important files (for example,
the Cisco IOS software image).
If the new Cisco IOS image contains the same SPE firmware as the old one, no new code is downloaded
Note
to the SPEs.
OL-3418-02 B0
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
Upgrading SPE Firmware
5-21