Cisco AS5350 - Universal Access Server Configuration Manual page 45

Basic Configuration Using the Command-Line
Interface
Note The information herein applies to the Cisco AS5350, Cisco AS5400, and Cisco AS5400HPX universal
gateways. Note that the latter requires use of Cisco IOS release 12.2(2)XB or later.
After you have verified your basic setup, you are ready to begin configuring basic tasks that prepare your
system for data call processing.
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to commission
your Cisco AS5350 or Cisco AS5400 universal gateway and includes the following tasks:
Configuring the Host Name, Password, and Time Stamps, page 3-2
•
• Configuring Local AAA Security, page 3-4
Creating a Login Banner, page 3-5
•
• Configuring Loopback Interfaces, Fast Ethernet Interfaces, and IP Route, page 3-6
Configuring the Asynchronous Group Interface, page 3-7
•
• Configuring Channelized T1 and E1 Trunk Cards, page 3-9
Configuring a Channelized T3 Trunk Card, page 3-11
•
• Configuring ISDN PRI, page 3-13
• Configuring DS0 Trunk Group Dial Out, page 3-20
Configuring the D Channels for ISDN Signaling, page 3-23
•
Configuring the Universal Port Card and Lines, page 3-26
•
• Configuring Clocking, page 3-31
• Enabling IP Basic Setup, page 3-36
Testing Asynchronous Shell Connections, page 3-37
•
• Verifying the Final Running-Configuration, page 3-39
Saving Configuration Changes, page 3-41
•
After commissioning your gateway, proceed to Chapter 4 to configure the software features that are most
Note
commonly used on your system.
OL-3418-02 B0
Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide
C H A P T E R
3
3-1