Power Cable; Powering Up; Setting Ip Addresses - Cisco 3005 - VPN Concentrator - Gateway Operation Manual

C I SCO SYSTEM S, IN C.
For ASF output, any of the Ethernet ports can be used to send data. For MPEG-2 TS
output, only the Main data port is used. For Web management, any of the Ethernet ports
can be used.
NOTE:

Power Cable

Connect the properly grounded power cable to the AC power connector.

Powering Up

Except for the Cisco S3200 Series media Processor unit, place the On/Off switch on the
back of your Media Processor in the On position. Next, press and release the Power
switch on the front of the Media Processor.

Setting IP Addresses

The Ethernet ports for the Cisco Media Processor are configured to obtain IP addresses
using DHCP. Once the unit has been powered on, the front panel can be used to see
the IP address that was obtained using DHCP. If not using DHCP, you may use the
front panel to set IP addresses manually.
NOTE:
To view or set the Media Procesor IP address, complete these steps:
1.
For S3200 Series units only, press right at either the Channel 1 or Channel
2 menu item to get to the Main Menu.
2.
Press the up or down keys to get to the IP Address Menu.
3.
Press right to get to the LAN1 or LAN2 IP Menu.
4.
Press right again to see the IP address. If this address is acceptable, then
you can now use a Web browser to connect to the machine. Go to Chapter
3: Web Interface for information on how to operate the Media Procesor
remotely via the Web Interface.
Do not use the IPMI port for network connections.
For more information on how to use the Front Panel, see Chapter 4:
Front Panel Controls on page 40.
6