Cisco 3005 - VPN Concentrator - Gateway Operation Manual page 15

5.
To change the address, press the Enter ( ) button.
6.
The IP address is now editable. Use the up and down buttons to change
the number. Use the right and the left buttons to scroll across the numbers
to the digit that needs changing. The IP address is always a fixed 12-digit
value, with leading zeroes to pad each octet and decimal points in fixed
positions. For example, 192.168.1.10 is represented as 192.168.001.010.
7.
Once a valid IP address is entered, press the Enter ( ) button.
8.
Press the down button to navigate to the Netmask and Gateway settings.
Repeat steps 4, 5, and 6 for the Netmask and Gateway settings.
9.
Once the IP address, Netmask, and Gateway are set correctly, press the
down button to the DHCP menu item and confirm that it is off. DHCP should
automatically be turned off when you edit the IP address. If it is not off, then
press the Enter ( ) button to edit the setting, then up to set it to Off, then
press the Enter ( ) button again to save the setting.
10.
Once DHCP is set to Off, press the left button to go back to the LAN1 or
LAN2 IP menu.
11.
When asked whether to apply changes, choose yes to commit the changes.
12.
To verify the IP address has been set correctly, press Cancel (X) to return to
the top level menu, and proceed through steps 1 through 4 to see the
updated IP address. You can continue and set the other IP addresses
through the front panel, but typically once the Media Procesor IP address is
set, it is easier to set the remaining ports through the Web interface.
C I SCO S3 0 00 / S 50 0 0 S ER I E S M E D I A PRO C E S SO R S
7