Enclosure; Modifications; Emc - Cisco 3005 - VPN Concentrator - Gateway Operation Manual

Instructions for Reconfiguring Rack Mounting Brackets for Mid-
Mounting:
1.
Remove and retain the eight (8) screws securing the 2 rack mounting
brackets to the chassis side walls.
2.
Slide both brackets back 5 inches (125mm) until all 4 countersunk holes in
each bracket align with 4 threaded holes in chassis side walls.
3.
Reinstall the eight (8) screws through the 2 rack brackets and into the
threaded holes in the chassis side walls. Torque to 20 lbs-in (2.25 N-m).

Enclosure

Do not open the Media Procesor as this will void the product warranty. Do not allow
moisture or any objects to enter openings in the enclosure.

Modifications

Do not make any modifications to this equipment. Modifications may put people or
property at risk of injury or damage by potentially degrading the level of protection built
into the equipment.

EMC

Where this equipment is subject to USA FCC rules, the following statement applies:
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device according to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when this equipment is operated in a
commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with this operations manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area
iii