Accessory Kit To Use; Installation Procedure - Cisco 1841 - 3G Bundle Router Hardware Installation Manual

Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)
Table 11-1
Cisco Part Number
AIM-CUE=
AIM2-CUE-K9
AIM2-APPRE-104-K9
AIM-IPS
AIM-VPN-EPII-PLUS
Caution When you install an AIM, always wear an ESD-preventive wrist strap, and ensure that it makes good
contact with your skin. Connect the equipment end of the wrist strap to the metal part of the chassis.
Handle AIMs by the edges only. AIMs are ESD-sensitive components and can be damaged by
Caution
mishandling.

Accessory Kit to Use

Some AIMs are provided with multiple accessory kits that contain different configurations of mounting
hardware. Mounting hardware for the Cisco 1841 router consists of two machine thread metal standoffs,
two machine thread metal screws, and one plastic standoff.
To install an AIM2-CUE-K9 or an AIM2-APPRE-104-K9, use the snap-fit blue standoff, the two hex
standoffs, and the two M2.5 screws found in mounting kit 69-1870-01. You can discard the remaining
parts.
For all other AIM module installations, use the hardware found in mounting kit 69-1316-01.

Installation Procedure

To install the AIM, perform the following steps. You need a number 2 Phillips screwdriver or flat-head
screwdriver to complete this procedure.
Find the metal standoff attachment locations on the system board near the AIM connector, indicated by
Step 1
a star pattern, as shown in
OL-5876-03
AIMs Supported on Cisco 1841 Router
Figure 11-7.
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
Modules Internal to the Cisco 1841 Router
Type
Unity Express
Unity Express
AXP—Application eXtension Platform
Intrusion Prevention Systems
VPN Encryption
11-7