Verifying The Led Indicators On The 1841 Router; Verifying The Led Indicators On The 1861 Integrated Services Router - Cisco 1841 - 3G Bundle Router Hardware Installation Manual

Verifying the LED Indicators on the 1841 Router

Note
Verifying the LED Indicators on the 1841 Router
Verify that you have correctly installed the router by checking the LEDs shown in
Table 7-1
LED
SYS PWR
SYS ACT
CF
Verifying the LED Indicators on the 1861 Integrated Services
Router
Verify that you have correctly installed the router by checking the LEDs shown in
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
7-4
.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If the prompt appears, your system has booted in ROM monitor mode. For
rommon 1>
information about the ROM monitor and the bootstrap program, see the
Monitor" section in Cisco 1800 Series Router Software
LED Indicators
Color
Green
Green
Blinking
green
Chapter 7 Power-Up Procedures for Cisco 1800 Series Routers (Modular)
Status
Router has successfully booted up and the software is functional. Slow,
steady blinking when system is booting or in the ROM monitor.
Blinking when packets are transmitted or received on any WAN or LAN
interface, or when monitoring system activity.
Flash memory is busy. Do not remove the CompactFlash memory card
when this light is on.
"Using the ROM
Configuration.
Table 7-1.
Figure 7-1.
OL-5876-03