Applying The Aim Label; Closing The Chassis - Cisco 1841 - 3G Bundle Router Hardware Installation Manual

Chapter 11 Installing and Upgrading Internal Modules in Cisco 1800 Series Routers (Modular)
Figure 11-10

Applying the AIM Label

The AIM label for the chassis might be in the AIM mounting kit, or it might be attached to the label on
the AIM card. To apply the chassis label, follow these steps:
If the chassis label is attached to the label on the AIM card, carefully tear off the chassis label at the
Step 1
perforation. If the chassis label is in the AIM mounting kit, remove the label from the kit bag.
Peel the chassis label from its backing.
Step 2
If there is a suitable space, apply the chassis label to the back of the chassis. If no suitable space is
Step 3
available on the back of the chassis, apply the label to the top cover at the back edge. The label must be
visible with the chassis installed.
Note

Closing the Chassis

To close the chassis, follow these steps:
Rotate the cover down onto the chassis. Slide the cover back onto the bottom of the chassis. See
Step 1
Figure
Push firmly to close.
Step 2
Turn the router upside-down.
Step 3
OL-5876-03
Correctly Installed AIM
Do not apply the AIM label for the chassis to a blank cover plate; to any removable network
module or interface card; or over any holes, screws, chassis vents, or existing labels.
11-11.
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
Modules Internal to the Cisco 1841 Router
11-11