Table of Contents
Advertisement
Installation
Installing the VCR
Foam pads
Installing the Enclosure Cover
Rev B
Note
If you are replacing an HTR62 unit with this HTR1 unit, you need to replace
the foam pads, locations indicated in
Honeywell representative for replacement pads.
To install the VCR:
1.
Slide the VCR into the foam padded holder in the VCR enclosure base and secure it in
place with the velcro retaining strap. Do not press on the center of the VCR.
2.
For inverted mount installations, see
Figure 2-3
Enclosure Inverted Mount Installation
VCR
To install the enclosure cover:
1.
Unlock the access panel in the front of the enclosure cover, using one of the keys
supplied with the VCR enclosure.
2.
Place the enclosure cover inside the side rails of the enclosure base.
3.
Slide the cover toward the rear of the base (see
4.
Replace the access panel and lock it to secure the cover to the base.
Figure
Figure
2-3.
Inverted VCR enclosure base
Foam pads
Figure
20
2-3. Please contact your
2-4).
Document 800-00759
11/07
Advertisement
Table of Contents
