Navigating The Menu Screen - Honeywell HTR1 Installation And Operating Manual

System Setup

Navigating the Menu Screen

Cursor
Current Time and Date
DST Indicator
Camera trigger status indicators
Daily timers
1-4
Rev B
Note You can program the VCR when no video camera is connected to the system.
In this case the message NO VIDEO DETECTED displays on the screen.
Table 3-2 Menu Screen, Default Settings Shown
Title line (up to 20 characters)
For example, Bus ID
XXXXXXXXXXXXXXXXXXX
10:09:07
BRK STP
FSH ARM
12:00 12:00
12:00 12:00
12:00 12:00
12:00 12:00
Bus ID String
Tool-Tip (explains cursor field)
Use the following tools and symbols to navigate the HTR 1 screens.
Cursor
The current position of the Cursor is shown in reverse video on the menu screen. In the
example below, the cursor is on 2.
BUS 23
Tool-Tip Text
When you hover your cursor over a field, the tool-tip appears in the bottom line of the
screen.
These tool-tips always appear in
DT 1/ 7/2008
TRN
00 00 EP
MPH
REVERSE VIDEO
26
Bus ID on/off
Reset/restore defaults
Daylight Saving Time on/off
Record START delay
Record STOP delay
Record Speed (EP/SP)
Record Mode
GPS Direction
GPS Position (latitude/longitude)
Speed Units (MPH/KPH)
= Parameter is enabled
= Parameter is disabled
Document 800-00759
11/07