Advertisement
2
Programming the VCR
1.
Install the two AAA/UM4 (size E92) batteries (supplied) into the
remote control.
2.
Remove or open access panel on enclosure cover.
3.
Plug RCA cable into VIDEO OUT jack on front of VCR. Plug other
end into VIDEO IN jack of a portable monitor.
Start vehicle. Press MENU on the remote control to enter the Program
mode. To apply temporary power to program the VCR without turning
the bus ignition on, use the VCR POWER button.
Turns unit off
Program mode
TRK
Move cursor right
TRK
Move cursor left
Enter/exit Program mode
UP/DOWN
Change value
and character
ENTER
Select action
MENU
Display or exit Menu
User configurable settings
You can change any of the pre-configured factory settings shown
below.
Text line (up to 20 characters)
For example, Bus ID
XXXXXXXXXXXXXXXXXXX
Current time, date
10:09:07
DT
and DST indicator
BRK
STP
5 Trigger
indicators
FSH
ARM
Tool text tip line provides setting descriptions
12:00
12:00
4 Daily
12:00
12:00
timers
12:00
12:00
12:00
12:00
Bus ID String
All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell Video Systems. The information in this publication is believed to be
accurate in all respects. However, Honeywell Video Systems cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to
change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
Ejects VCR tape
Playback or Record mode
REC/PLAY
Change Rec and Play
HOURS
speeds (EP or SP)
Pause
Stop playback or recording
Record video
Playback video
Play mode
Video tracking
Playback images fast forward
Rewind tape/search images
Bus ID on/off
Reset/restore defaults
1/ 7/2008
DST = Daylight Saving Time on/off
TRN
Start Delay (0-60 mins)
Record stop delay (0-54 mins)
00 00 EP
Record speed
MPH
Recording mode
Speed in MPH or KPH
GPS direction
GPS latitude/longitude
= Feature is enabled
Selected trigger is active
= Parameter is disabled
Selected trigger is inactive
Legend: Status Indicators
= Input enabled; system will display
= Display is active when input is 12 volts OR
= Display is active when input is grounded
BRK
= Unit switches inputs (e.g., to Stop Arm camera)
= Unit does not switch camera inputs.
4.
Press MENU to exit Program mode, then POWER on front of VCR
to start recording.
3
Daily operation
Receives
infrared signals
from remote
control
Legend:
POWER
= Turns VCR on for temporary power
EJECT
= Press to eject tape
REW
= Rewind tape, search backward through images
PLAY
= Play back tape
FF
= Advance tape or search forward through images
STOP
= Stop recording
REC
= Press to record
POWER Indicator = Lights when the HTR1 is plugged into a power source
EP Indicator
= Lights when the HTR1 is in EP mode
REC Indicator
= Lights when the HTR1 is recording
Specifications subject to change without
notice. Imperial conversions are approximate.
HTR1 Quick Start Guide
Daily Timers
= Parameter is enabled
= Parameter is disabled
Note Make sure all
timers are disabled (
if not used.
Video Systems
www.honeywellvideo.com
+1.800.796.CCTV (North America only)
Document 800-00760 Rev A 11/07
© 2007 Honeywell International Inc.
)
Advertisement
