Table of Contents
Advertisement
Lockable access panel
Upgrade Installation
Disassembling the Existing System
Rev B
Figure 2-4
Enclosure Cover Installation
Your HTR1 unit is now ready to program. Proceed to
This section explains how to upgrade an existing mobile video system (for example, a Silent
Witness SWS310 or SWS210) to an HTR1 system. You will require only a VCR to complete
the upgrade.
Note
If the main wiring harness is not replaced when upgrading, trigger 5 may not
be available.
To disassemble the existing system:
1.
Remove the enclosure cover:
a.
Unlock the access panel in the front of the enclosure cover.
b.
Slide the access panel to the right and remove it from the enclosure cover.
c.
Pull the enclosure cover towards you until it is free of the enclosure base.
2.
Make a note of the current system configuration settings:
a.
Power up the VCR.
b.
Enter programming mode (refer to the manual that came with your existing
system).
HTR1 Installation and Operating Guide
Enclosure base (rear)
Enclosure cover
Side rails
Chapter 3, System
21
Setup.
Document 800-00759
11/07
Advertisement
Table of Contents
