Determining the MAC Address for a Cisco Unified IP Phone
Adding Phones with BAT
Determining the MAC Address for a Cisco Unified IP
Phone
Cisco Unified SIP Phone 3911 Administration Guide for Cisco Unified Communications Manager
2-12
Chapter 2
Related Topics
Adding Phones with Cisco Unified Communications Manager
•
Administration, page 2-11
Adding Phones with BAT, page 2-12
•
Cisco Unified Communications Manager Bulk Administration (BAT) is a
web-based application that enables you to perform bulk transactions, including
registering, multiple phones to the Cisco Unified Communications Manager
database.
Before you can use BAT to add phones, you must obtain the MAC address for each
phone.
For information about determining a MAC address, see the
MAC Address for a Cisco Unified IP Phone" section on page
For detailed instructions about using BAT, refer to Cisco Unified Communications
Manager Administration Guide and to Cisco Unified Communications Manager
Bulk Administration Guide.
Related Topics
Adding Phones with Auto-Registration, page 2-10
•
Adding Phones with Cisco Unified Communications Manager
•
Administration, page 2-11
Several procedures described in this manual require you to determine the MAC
address of a Cisco Unified IP Phone. You can determine a phone's MAC address
in these ways:
From the phone, press the OK button and select Settings > Network
•
Configuration > Mac Address to display the MAC Address field.
Look at the MAC label on the back of the phone.
•
Preparing to Install the Cisco Unified IP Phone on Your Network
"Determining the
2-12.
OL-14029-01