Adding Phones With Cisco Unified Callmanager Administration; Adding Phones With Bat - Cisco 3951 Administration Manual

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network

Adding Phones with Cisco Unified CallManager Administration

Adding Phones with BAT

OL-10969-01
In some cases, you might not want to use auto-registration: for example, if you
want to assign a specific directory number to the phone. For information about
enabling auto-registration, refer to "Auto-Registration Configuration" in the
Cisco Unified CallManager Administration Guide.
Related Topics
Adding Phones with Cisco Unified CallManager Administration, page 2-11
•
Adding Phones with BAT, page 2-11
•
You can add phones individually to the Cisco Unified CallManager database
using Cisco Unified CallManager Administration. To do so, you first need to
obtain the MAC address for each phone.
For information about determining a MAC address, see the
MAC Address for a Cisco Unified IP Phone" section on page
After you have collected MAC addresses, in Cisco Unified CallManager
Administration, choose Device > Phone and click Add New to begin adding
phones to the Cisco Unified CallManager database.
For complete instructions and conceptual information about Cisco Unified
CallManager, refer to Cisco Unified CallManager Administration Guide and to
Cisco Unified CallManager System Guide.
Related Topics
Adding Phones with Auto-Registration, page 2-10
•
Adding Phones with BAT, page 2-11
•
Cisco Unified CallManager Bulk Administration (BAT) is a web-based
application that enables you to perform bulk transactions, including registering,
multiple phones to the Cisco Unified CallManager database.
Before you can use BAT to add phones, you must obtain the MAC address for each
phone.
Cisco Unified SIP Phone 3951 Administration Guide for Cisco Unified CallManager 5.1
Adding Phones to the Cisco Unified CallManager Database
"Determining the
2-12.
2-11