Pvc Delete Command; Priority-Based Pvcs; Figure 273 Pvc Set Command Example - ZyXEL Communications IES-1248-51 User Manual

[,US
vcprofile]>
This command allows the configuration of a PVC (permanent virtual circuit) for one or a
range of ADSL ports.
The following example sets a PVC on ADSL port 1 with VPI 1, VCI 34, default VID 100
priority 3. It sets the "platinum" profile for downstream traffic shaping and a VC profile
named "plus" for upstream traffic policing.

Figure 273 PVC Set Command Example

ras> adsl pvc set 1 1 34 100 3 platinum,plus

56.3.3 PVC Delete Command

Syntax:
ras> adsl pvc delete <portlist> <vpi> <vci>
where
<portlist>
[<vpi> <vci>]
This command deletes the specified PVC channel.

56.4 Priority-based PVCs

A PPVC (Priority-based PVC) allows you to give different priorities to PVCs that are
members of the same VLAN.
The IES-1248 uses eight priority queues (also called levels) for the member PVCs. The system
maps frames with certain IEEE 802.1p priorities to a PVC with a particular priority queue. See
Chapter 16 on page 119
Use these commands to configure PPVCs and add and remove member PVCs.
Chapter 56 Virtual Channel Management
Assign a VC profile to use for policing this channel's upstream
=
traffic. The IES-1248 does not perform upstream traffic policing
if you do not specify an upstream VC profile.
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
The VPI and VCI of an individual PVC.
=
for the factory default mapping.
IES-1248-51/51A/53 User's Guide
403