Figure 119 Acl Setup; Table 68 Acl Setup - ZyXEL Communications IES-1248-51 User Manual

Figure 119 ACL Setup

The following table describes the labels in this screen.

Table 68 ACL Setup

LABEL
ACL Profile Setup
ACL Profile Map
Port
VPI
VCI
ACL Profile
Apply
Cancel
Show Port
Index
Port
VPI/VCI
ACL Profile
Select
Delete
Chapter 34 ACL
DESCRIPTION
Click ACL Profile Setup to open the screen where you can set up ACL profiles
(see Section 34.3 on page
Click ACL Profile Map to open the screen where you can look at which ACL
profiles are assigned to which PVCs (see
Use this drop-down list box to select a port to which you wish to assign an ACL
profile. This field is read-only once you click on a port number below.
Type the Virtual Path Identifier for a channel on this port.
Type the Virtual Circuit Identifier for a channel on this port.
Use the drop-down list box to select the ACL profile you want to assign to this
PVC.
Click this to save your changes to the IES-1248's volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to start configuring the screen again.
Select which ADSL port(s) for which to display ACL profile settings.
This field displays the number of the PVC. Click a PVC's index number to use
the top of the screen to edit the PVC.
Note: At the time of writing, you cannot edit the VPI and VCI. If
you want to change them, add a new PVC with the desired
settings. Then you can delete any unwanted PVCs.
This field displays the number of the ADSL port on which the PVC is configured.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify a channel on this port.
This field shows the ACL profile assigned to this PVC.
Select the check box in the Select column for an entry, and click Delete to
remove the entry.
IES-1248-51/51A/53 User's Guide
230).
Section 34.4 on page 232).
229