49.3.2 MAC Count Enable Command
Syntax:
ras> switch mac count enable <portlist>
where
<portlist>
This command enables the MAC count filter on the specified ADSL port(s). When the MAC
filter accept mode is enabled (see
count setting and accepts all of the MAC addresses listed for the port in the MAC filter
settings.
The following example turns on the MAC count filter on ADSL port 4.
Figure 179 MAC Count Enable Command Example
ras> switch mac count enable 4
49.3.3 MAC Count Disable Command
Syntax:
ras> switch mac count disable <portlist>
where
<portlist>
This command disables the MAC filtering feature on the specified ADSL port(s).
The following example turns off the MAC count filter on ADSL port 4.
Figure 180 MAC Count Disable Command Example
ras> switch mac count disable 4
Chapter 49 MAC Commands
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Section 49.2 on page
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
IES-1248-51/51A/53 User's Guide
321), the IES-1248 ignores the MAC
325