IES-1248-51/51A/53 User's Guide
49.3.4 MAC Count Set Command
Syntax:
ras> switch mac count set <portlist> <count>
where
<portlist>
<count>
This command sets the limit for how many MAC addresses may be dynamically learned on
the specified ADSL port(s).
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on ADSL port 7.
Figure 181 MAC Count Set Command Example
ras> switch mac count set 7 50
326
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
Set the limit for how many MAC addresses that a port may
=
dynamically learn. For example, if you are configuring port 2
and you set this field to "5", then only five devices with
dynamically learned MAC addresses may access port 2 at any
one time. A sixth device would have to wait until one of the five
learned MAC addresses ages out.
The valid range is from "1" to "128".
Chapter 49 MAC Commands