The ENET Port Setup screen allows you to configure settings for the Ethernet ports.
To open this screen, click Basic Setting, ENET Port Setup.
Figure 56 ENET Port Setup
The following table describes the labels in this screen.
Table 17 ENET Port Setup
LABEL
Port
Active
Name
Speed Mode
Duplex
Chapter 15 ENET Port Setup
C
ENET Port Setup
DESCRIPTION
This is the port index number.
Select the check box to turn on the port. Clear it to disable the port.
Enter a descriptive name that identifies this port. You can use up to 31 ASCII
characters; spaces are not allowed.
Select the type of Ethernet connection for this port. When you don't use auto-
negotiation, you must make sure that the settings of the peer Ethernet port are
the same in order to connect.
Select Auto (auto-negotiation) to have the IES-1248 automatically determine the
type of connection that the Ethernet port has. When the peer Ethernet device
has auto-negotiation turned on, the IES-1248 negotiates with the peer to
determine the connection speed. If the peer Ethernet port does not have auto-
negotiation turned on, the IES-1248 determines the connection speed by
detecting the signal on the cable and using full duplex.
When an Ethernet port is set to Auto, the IES-1248 tries to make a fiber
connection first and does not attempt to use the RJ-45 port if the fiber
connection is successful.
Select 100 Copper if the Ethernet port has a 100 MB electrical connection.
Select 1000 Copper if the Ethernet port has a 1000 MB (1 gigabit) electrical
connection.
Select 1000 Fiber if the Ethernet port has a 1000 MB (1 gigabit) fiber optic
connection.
The IES-1248 uses full duplex Ethernet connections.
IES-1248-51/51A/53 User's Guide
H A P T E R
1 5
117