Verifying The Initial Configuration - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Configuring the Router
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, then the Cisco SDM software and a default configuration file were
installed on the router at the factory. To use SDM to configure your router, see the
Using Cisco Router and Security Device Manager" section on page
For a description of interface and port numbering, see the
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 To terminate autoinstall and continue with manual configuration, press Return:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with lines similar to the following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled < date > < time > by < person >
To bring up the
Step 3
...
flashfs[4]: Initialization complete.
Router>
Enter privileged EXEC mode:
Step 4
Router> enable
Router#
Step 5 For configuration procedures, see the online document
(Fixed) Software Configuration
Note
After you finish the initial configuration, you need to verify the initial configuration. See the
Step 6
the Initial Configuration" section on page 5-8

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, enter commands as follows:
•
•
•
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
5-8
prompt, press Return:
Router>
To avoid losing the work that you have completed, be sure to save your configuration
occasionally as you proceed. Use the copy running-config startup-config command to save the
configuration to NVRAM.
To verify that the interfaces are operating correctly and that the interfaces and line protocol are in
the correct state—up or down—enter show interfaces.
To display a summary status of the interfaces configured for IP, enter show ip interface brief.
To verify that you configured the correct hostname and password, enter show configuration.
Chapter 5
Cisco 1800 Series Integrated Services Router
Guide.
for verification procedures.
Power-Up and Initial Configuration Procedures
"Initial Configuration
5-4.
"Interface Numbering" section on page 1-11.
"Verifying
OL-6425-03