Initial Configuration Using Cisco Router And Security Device Manager; Initial Configuration Using The Setup Command Facility - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Configuring the Router
•
You can configure your router by using one of the following tools:
•
•
•
Note For a description of the interface and port numbering, see the
page

Initial Configuration Using Cisco Router and Security Device Manager

The following messages appear at the end of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For instructions on configuring your router by using Cisco Router and Security Device Manager (SDM),
see the Cisco Router and Security Device Manager (SDM) Quick Start Guide that shipped with your
router. If the above messages do not appear, then the Cisco SDM software and the Cisco Router and
Security Device Manager (SDM) Quick Start Guide were not shipped with your router. If you want to
use SDM, you can download the latest version of SDM and instructions for installing it from the
following location:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to
www.cisco.com/go/sdm and click the Technical Documentation link.
For a description of the interface and port numbering, see the
page

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a hostname for the router, set
passwords, and configure an interface for communication with the management network. If you see the
following messages at the end of the startup sequence, the setup command facility has been invoked
automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
5-4
Completing the Configuration
Cisco Router and Security Device Manager—See the
Security Device Manager" section on page
Setup command facility—See the
section on page 5-4.
Command-line interface (CLI)—See the
Configuration" section on page
1-11.
1-11.
Chapter 5
"Initial Configuration Using Cisco Router and
5-4.
"Initial Configuration Using the Setup Command Facility"
"Initial Configuration Using the Cisco CLI—Manual
5-7.
"Interface Numbering" section on
"Interface Numbering" section on
Power-Up and Initial Configuration Procedures
OL-6425-03