Installing A Compactflash Memory Card - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Removing and Installing CompactFlash Cards
Figure 7-5
PPP
B2
1

Installing a CompactFlash Memory Card

To install a CompactFlash memory card, perform the following steps (see
Make sure that the ejector button is pressed flush with the front panel, so that it does not project beyond
Step 1
the panel.
Note
Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains
Step 2
flush with the panel.
Note
To prevent damage to the ejector mechanism, the ejector button must remain pressed flush against the
Caution
front panel when it is not being used to eject a CompactFlash memory card.
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
7-8
CompactFlash Memory Card Slot in Cisco 1800 Series Fixed-Configuration Routers
VPN
CF
2 1
CompactFlash slot
If the ejector button is projecting beyond the panel, push it in until it is flush with the bezel.
If the ejector button is projecting from the panel after you insert the CompactFlash memory card,
remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the
CompactFlash memory card.
Chapter 7
Cisco 1
2
Ejector button
Installing and Upgrading Internal Modules
Figure 7-5):
OL-6425-03