Chapter 5 Power-Up And Initial Configuration Procedures; Powering Up Cisco 1800 Series Fixed-Configuration Routers; Checklist For Power Up - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Power-Up and Initial Configuration Procedures
This chapter describes how to power up your Cisco 1800 series fixed-configuration router and perform
an initial configuration for network access. This chapter includes the following sections:
•
•

Powering Up Cisco 1800 Series Fixed-Configuration Routers

This section includes the following topics:
•
•
•
•

Checklist for Power Up

After you ensure that the following conditions have been met, you can power up the Cisco 1800 series
fixed-configuration router:
•
•
•
•
•
•
•
•
OL-6425-03
Powering Up Cisco 1800 Series Fixed-Configuration Routers, page 5-1
Configuring the Router, page 5-3
Checklist for Power Up
Power-Up Procedure
Verifying the Front Panel LED Indications
Verifying the Hardware Configuration
The chassis is securely mounted and grounded.
The power and interface cables are connected.
The external CompactFlash memory card is properly seated into its slot. For installation
instructions, see the "Removing and Installing CompactFlash Cards" section on page
A PC with terminal emulation program (HyperTerminal or equivalent) is connected to the console
port and powered up.
Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, and no
parity, and flow control is set to "none."
A suitable PC COM port is selected in the terminal emulation program.
You have selected passwords for access control.
You have determined the IP addresses for the Ethernet and serial interfaces.
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
5
C H A P T E R
7-7.
5-1