Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual page 58

Configuring the Router
A summary of the available interfaces appears.
Current interface summary
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
Async1
FastEthernet0
FastEthernet1
FastEthernet2
FastEthernet3
FastEthernet4
FastEthernet5
FastEthernet6
FastEthernet7
FastEthernet8
FastEthernet9
Vlan1
Step 8 Choose one of the available interfaces for connecting the router to the management network:
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0
Respond to the following prompts as appropriate for your network:
Step 9
Configuring interface FastEthernet0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.16.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.16.0.0, 16 subnet bits; mask is /16
The configuration is displayed:
Step 10
The following configuration command script was created:
hostname Router
enable secret 5 $1$AaVU$9tl.HLXo/M1oYglcLDVIN1
enable password 654321
line vty 0 4
password 123456
snmp-server community public
!
no ip routing
!
interface FastEthernet0
no shutdown
media-type 100BaseX
full-duplex
ip address 172.16.2.3 255.255.0.0
!
interface FastEthernet1
shutdown
no ip address
!
interface FastEthernet2
shutdown
no ip address
!
interface FastEthernet3
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
5-6
Chapter 5
IP-Address OK? Method Status
unassigned YES unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned NO unset
unassigned YES unset
Power-Up and Initial Configuration Procedures
Protocol
down down
up up
up down
initializing down
initializing down
initializing down
initializing down
initializing down
initializing down
initializing down
initializing down
up down
OL-6425-03