Initial Configuration Using The Cisco Cli-Manual Configuration - Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual

Chapter 5 Power-Up and Initial Configuration Procedures
shutdown
no ip address
!
interface FastEthernet4
shutdown
no ip address
!
interface FastEthernet5
shutdown
no ip address
!
interface FastEthernet6
shutdown
no ip address
!
interface FastEthernet7
shutdown
no ip address
!
interface FastEthernet8
shutdown
no ip address
!
interface FastEthernet9
shutdown
no ip address
!
interface Vlan1
shutdown
no ip address
!
end
Respond to the following prompts. Enter 2 to save the initial configuration:
Step 11
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The user prompt appears.
Router>
Verify the initial configuration. See the
Step 12
verification procedures.
Initial Configuration Using the Cisco CLI—Manual Configuration
This section describes how to display a command-line interface (CLI) prompt for configuration using
the CLI, and it directs you to documentation for the CLI configuration. You can use the CLI if you see
the following messages at the end of the startup sequence:
--- System Configuration Dialog ---
OL-6425-03
"Verifying the Initial Configuration" section on page 5-8
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
Configuring the Router
for
5-7