Cisco CISCO1841 - 1841 Integrated Services Router Hardware Installation Manual page 38

Required Tools and Equipment for Installation and Maintenance
• Ethernet cables for connection to the Fast Ethernet WAN and LAN ports
Note
• Ethernet hub or PC with a network interface card for connection to a Fast Ethernet (LAN) port
• Console terminal (an ASCII terminal or a PC that is running HyperTerminal or similar terminal
emulation software) configured for 9600 baud, 8 data bits, 1 stop bit, no flow control, and no parity
• Modem for connection to the auxiliary port for remote administrative access (optional)
• NT1 device for ISDN BRI S/T interfaces (if this device was not supplied by your service provider)
• Wall-mount or ceiling-mount antennas for wireless routers (if you do not intend to use the supplied
dipole antennas)
Cisco 1800 Series Integrated Services Routers (Fixed) Hardware Installation Guide
2-8
For more information on cable specifications, see the online document
Access Router Cable Specifications
Chapter 2
on Cisco.com.
Preinstallation Requirements
Cisco Modular
OL-6425-03