Initial Configuration Using The Cli (Manual Configuration) - Cisco 3700 Series Hardware Installation Manual

Configuring the Router
Press RETURN to get started!
The user prompt appears:
Step 12
3700>
After you complete the initial configuration tasks, your Cisco router is ready to configure for specific
functions. For configuration procedures, see the
Cisco 3600 Series, and Cisco 3700 Series Routers
documentation. You can access these documents on Cisco.com.

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the
CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the
following messages at the end of the startup sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file have been installed on the router
Note
at the factory. To use SDM to configure the router, see the quick start guide that shipped with your router.
You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3700/37xx_qsg/index.htm
To avoid losing work you have completed, be sure to save your configuration occasionally as you
Note
proceed. Use the copy running-config startup-config command to save the configuration to NVRAM.
To proceed with manual configuration using the CLI, enter no.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 Press Return to terminate autoinstall and continue with manual configuration.
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled < date > < time > by < person >
Cisco 3700 Series Routers Hardware Installation Guide
3-32
Software Configuration Guide for Cisco 2600 Series,
Cisco 3700 series routers quick start guides
Chapter 3
or the Cisco IOS software configuration
online at:
Installing the Router
OL-2180-08