Table of Contents
Advertisement
Snap: Click Snap, snapshot the current image picture when alarm triggered
Record: Click, it will do video record automatically when alarm triggered
Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch to make alarm output.
Snap count: Set the snapshot count in every second
Snap Interval: Set the snapshot interval time
Enable PTZ: Click Enable PTZ, it will linkage PTZ operation when alarm input
Preset: set the linkage preset point
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Alarm Output
IP Camera "Alarm Output" setting interface as figure 3-25.
Output Relay Status: Normally Open/ Normally Close selectable
Output Delay: Select the alarm output time( Alarm delay output when alarm triggered)
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Exception Settings
IP Camera "Exception Settings" interface as figure 3-26.
Figure 3-25
Honeywell
20
Advertisement
Table of Contents
