Table of Contents
Advertisement
Setting procedure:
1. Log in IP camera via the IE browser (the default IP is 192.168.1.188)
2. Switch to the page " Network Setting" interface, input the IP address. Default is 192.168.1.50
3. Fill in subnet mask, the default is 255.255.255.0
4. Fill in gateway address, the default is 192.168.1.1
After input all parameters, click "Save", then the device restart, Input the device IP address at the IE browser to visit the camera.
Dynamic IP
Dynamic IP means that IP camera obtains IP address from DHCP server. See below picture for the network topology:
Please refer to below picture for the network settings:
Log in IP camera via IE browser. Then turn to " Network Setting" interface, click DHCP"
After setting all the parameters, click save and restart to make the parameters valid.
Internet
There are three ways to connect IP camera to the Internet.
Honeywell
29
Advertisement
Table of Contents
