Table of Contents
Advertisement
Honeywell
Figure 3-16
Enable: Select whether open the motion detection function.
Alarm Schedule: Set the alarm schedule from Monday to Sunday.
Drawing: Click Drawing, then set the detective area.
Clear: Click Clear to clear the current detective areas.
Sensitivity: The higher of the sensitivity, the obvious of the motion detective.
Email: Send Email to appointed mailbox when alarm triggered.
Snap: Snapshot and install the picture in the HDD when alarm triggered.
Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch to make alarm output.
Enable PTZ: Alarm input to link the PTZ motion.
Preset: Alarm input to link the preset.
Snap Interval: Set the snapshot interval time
Snap Count: Set the snapshot count in every second
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Video Tampering
IP Camera "Video Tampering" setting interface as figure 3-17.
14
Advertisement
Table of Contents
