Table of Contents
Advertisement
1. Fixed IP mode
2. ADSL broadband and router share online mode( Dynamic get the IP address mode)
3. PPPOE dial-up access
After IP camera is connected to Internet, remote Internet users can visit it directly via domain name or IP address.
Fixed IP mode
See below picture for the network topology:
Please refer to below picture for the network settings:
Setting steps:
1.
Log in IP camera via crossover cable direct connection.(For details, please refer to "Hardware Installation")
1. Switch to the page network settings, fill in the device IP address requested from network service provider in to Basic
Parameters, such as 218.84.31.168
2. enter correct subnet mask. Such as 255.255.255.0
3. enter correct gateway address. Such as 218.84.31.131
After setup completes, click Save and restart the device, then connect it to public network so that all Internet users can visit the IP camera
remotely via entering http://218.84.31.168 to IE browser
Broadband and router sharing Internet access mode (dynamic obtainment of extranet IP address mode) like ADSL and so on.
If you select router dial-up to connect internet, see below picture for the network topology:
Honeywell
30
Advertisement
Table of Contents
