Table of Contents
Advertisement
Day&Night Mode: Outside Trigger/ Auto/ Color/ Black White four kinds of mode selectable. Non infrared IP cameras default mode is
Auto, and infrared IP cameras default mode is Outside Trigger. According to the IP camera type and actual scene to select the
Day&Night mode.
Switch time: Day&Night switch delay time, 0-30s selectable, and default is 3s.
Day-Ni-Threshold: 0-255 selectable, users adjust it according to the need, default is 44.
Ni-Day-Threshold: 0-255 selectable, users adjust it according to the need, default is 119.
Color: Normal/ Bright/ Nature three options, default is Normal.
Mirror: Close/ Horizonal Mirror/ Vertical Mirror/ 180° Rotation four options, default is Close.
WDR: Close/ Low/ Medium/ High four options, default is Close.
3DNR: Close/ Low/ Medium/ Higher/ High five levels, default is Close.
Sharpness: 0-255 selectable, default is 128.
Gain: Low/ Lower/ Medium/ Higher/ High selectable, default is Medium. The higher of the Gain, the more of the sharpness.
Sharpness: Auto, 1/30(25)-1/10000, the default is Auto
Exposure Control Mode: Auto/ Manual selectable, default is Auto.
Gamma: CURVE_1_6，CURVE_1_8,CURVE_2_0,CURVE_2_2 totally four modes, default is CURVE_2_0
Anti-Fliker: Auto, 50hz, 60hz, the default is Auto
After all parameters setting completed, click "Save" and the it comes into effect immediately.
Motion Detection
IP Camera "Motion Detection" setting interface as figure 3-16.
Figure 3-15
Honeywell
13
Advertisement
Table of Contents
