Alarm Configuration; Motion Detection - Honeywell PERFORMANCE LITE 2MP SD User Manual

Alarm Configuration

Motion Detection

To set motion detection:
1. Go to Config > Alarm > Motion Detection to set motion detection alarm.
1 Check "Enable Alarm" check box to activate motion based alarms. If unchecked, the camera will not send out any signals to
trigger motion-based recording to the NVR or CMS, even if there is motion in the video.
Trigger SD Recording: If selected, video will be recorded on an SD card on motion detection (This function is only available for
the models with SD card slot).
Trigger Email: If "Trigger Email" and "Attach Picture" are checked (email address must be set first in the Email configuration
interface), the captured pictures and triggered event will be sent into those addresses.
2. Set motion detection area and sensitivity. Click the "Area and Sensitivity" tab to go to the interface as shown below.
Move the "Sensitivity" scroll bar to set the sensitivity. Higher sensitivity value means that motion will be triggered more easily.
Select "Add" and click "Draw". Drag the mouse to draw the motion detection area; Select "Erase" and drag the mouse to clear
motion detection area.
After that, click the "Save" to save the settings.
3. Set the schedule of the motion detection. The setting steps are the same as the schedule recording setting (See schedule
recording setting for more details).
Performance Lite 2MP SD Camera - User Manual | Configuration 17