Setting Fence Stops - Grizzly G0490ZX Owner's Manual

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚, 90˚, and 135˚ (45˚ outward).
Tools Needed
Square 45°, 90° ...........................................1 Ea.
Phillips Head Screwdriver #2 ............................ 1
Sliding Bevel ...................................................... 1
Open-End Wrenches 10mm .............................. 2
Hex Wrench 4mm .............................................. 1
Setting 45° Fence Stop
DISCONNECT MACHINE FROM POWER!
1.
Loosen fence tilt lock knob and tilt fence
2.
approximately 45° onto stop bolt, then place
45° square against fence and table (see
Figure 73).
Figure 73. Fence adjusted 45˚.
Loosen jam nut on 45° positive stop bolt
3.
shown in Figure 74.
45° Positive
Stop Bolt
Figure 74. 45° positive stop bolt location.
Adjust stop bolt until fence is exactly 45°
4.
while resting on bolt (verify angle with 45°
square), then tighten jam nut loosened in
Step 3.
-50-
Setting 90° Fence Stop
1.
2.
3.
Qty
4.
Setting 135° Fence Stop
1.
2.
3.
Jam Nut
Jam Nut
4.
DISCONNECT MACHINE FROM POWER!
Loosen set screw in plunger lock collar, then
loosen fence tilt lock (see Figure 75).
Using a 90° square, adjust fence to 90° posi-
tion, then tighten set screw in plunger lock
collar.
If required, loosen Phillips head screw on
fence tilt scale, adjust fence tilt scale indicator
to 0°, then secure (see Figure 75).
Plunger Lock Collar
Figure 75. Adjusting fence to 90˚.
DISCONNECT MACHINE FROM POWER!
Loosen fence tilt lock, and position fence
against 135° stop bolt.
Loosen jam nut on 135˚ positive stop bolt
(see Figure 76).
Figure 76. Adjusting fence 135˚.
Adjust 135˚ positive stop bolt until fence is
135° while resting on bolt (check angle with
a sliding bevel set to 135°), then tighten jam
nut loosened in Step 3.
Model G0490ZX (Mfd. Since 05/23)
Fence Tilt Lock
Fence Tilt Scale
Fence Tilt
Scale Indicator
135° Positive
Stop Bolt