Setting Fence Stops - Grizzly G0725 Owner's Manual

Setting Fence Stops

The fence angle stops simplify the task of adjust-
ing the fence to 45° inward, 90°, and 45° outward
(135°).
Items Needed
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Open-End Wrench 10mm .................................. 1
Hex Wrench 6mm .............................................. 1
Flathead Screwdriver ......................................... 1
Setting 90° Fence Stop
1. DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilting handle (see Figure 26),
and press limit plate tab forward into limit
block rear slot.
Figure 26. Fence carriage overview.
3.
Use a 90° square to adjust fence to 90° (see
Figure 27), then tighten fence tilting handle.
Note: Fence should stop at 90º when it con-
tacts limit block shaft (see Figure 28).
90°
Square
Figure 27. Checking the 90º stop.
Model G0725 (Mfd. Since 02/20)
Qty
Fence Tilting
Handle
Fence Sliding
Handle
— If fence stops at 90° when it contacts limit
block shaft, it is adjusted correctly. No fur-
ther adjustments are necessary.
— If fence does not stop at 90° when it
contacts limit block shaft, 90° stop is not
adjusted correctly. Proceed to Steps 4–6.
4.
Bring fence to 90°, then loosen jam nut locat-
ed on rear of limit block shaft (see Figure 28)
Note: Keep limit plate in limit block rear slot
while making adjustments.
Inward Stop
Limit Block
Shaft
Figure 28. Fence stop parts identification.
5.
Turn limit block shaft until it contacts fence.
6.
Re-tighten jam nut. The 90° stop is now set
precisely.
Setting 45° Fence Stop
1. DISCONNECT MACHINE FROM POWER!
2. Loosen fence tilting handle, and release
fence from 90° limit block stop.
3.
Tip fence towards table as far as it will go,
ensuring limit plate stays in limit block rear
slot, then tighten fence tilting handle.
Note: When fence tilts towards table, it
will stop when it contacts inward stop (see
Figure 28).
Limit Plate
Tab
Limit Block
Rear Slot
Jam Nut
-23-