Setting Fence Stops - Grizzly G0495X Owner's Manual

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Tools Needed
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 12mm ................................................... 1
Wrench 24mm ................................................... 1
Phillips Screwdriver ........................................... 1
To set the 45˚ inward fence stop:
1. Remove the fence assembly from the jointer,
remove the Phillips head screws from the
plate shown in Figure 47 under the fence
carriage. The plate must be removed to
access the adjustment nuts.
Plate
Figure 47. Removing plate to access inward
fence stop.
2.
Re-install the fence assembly on the jointer.
-42-
Qty
Screws
Adjustment Nuts
3.
Using a 45˚ square, adjust the fence to the
45˚ inward position, as shown in Figure 48.
Figure 48. Example of adjusting fence 45˚
inward.
4. Loosen the jam nut shown in Figure 49.
Fence Stop Nut
Figure 49. 45˚ inward fence stop jam nut.
5. Adjust the 45˚ inward fence stop nut until
it makes contact with the back of the shaft
bracket.
6. Retighten the jam nut loosened in Step 4.
7.
Remove the fence assembly, re-install the
plate with the screws removed in Step 1, then
re-install the fence assembly.
Model G0495X (Mfd. Since 07/19)
Shaft Bracket
Jam Nut