Setting Fence Stops - Grizzly G0857 Owner's Manual

3. Loosen jam nut on the
Figure 57), and then rotate stop bolt clock-
wise a couple turns to move it down, so it
will clear the stop plate during adjustment
process in later steps.
Stop Plate
Stop Bolt
Jam Nut
Figure 57. Location of
and jam nut.
4.
Place straightedge along outfeed table and
position it so the end is just over infeed table,
then lower infeed table until gap between
infeed table and straightedge measures
Tip: It may be easier to have another person
help by holding the straightedge in position
while you adjust table and measure gap.
5. Rotate stop bolt (see Figure 57) counter-
clockwise to move it upward until it makes
firm contact with stop plate (see Figure 57).
6.
Hold stop bolt in place, and tighten jam nut
(see Figure 57) down firmly against the cast-
ing to secure stop bolt in place.
7.
Replace table covers and re-install release
knob.
8. Calibrate depth-of-cut
Calibrating Depth-of-Cut
Page 50).
-48-
⁄ " stop bolt (see
1
8
⁄ " infeed table stop bolt
1
8
⁄ ".
1
8
scale (refer
Scale on

Setting Fence Stops

Setting Fence Stops
The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Item(s) Needed:
Open-End Wrench 14mm .................................. 1
Sliding Bevel ...................................................... 1
Setting 45° Inward Stop
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence tilt lock, rotate stop block up,
then tilt fence approximately 45° inward onto
stop bolt (see Figure 58).
45° Inward
Stop Bolt
Stop
Block
Tilt Lock
Figure 58. Fence set to 45° inward.
3. Place sliding bevel set to 45° against fence
and table, as shown in Figure 59.
Sliding Bevel
Set to 45° Inward
to
Figure 59. Example of adjusting fence to 45°
Model G0857/G0858 (Mfd. Since 07/19)
Jam Nut
inward.
Qty